Components
Setup mode
  1. Rinse, peel, and quarter the potatoes. Place them in a large pot, add water to cover, and season with 1 teaspoon of salt.
  1. Place the pot over high heat. Once it begins to boil, reduce the heat and let it simmer for approximately 20 minutes, or until the potatoes become tender — test with a fork.
  2. While the potatoes are cooking, slice the garlic-poro stalk lengthwise down the middle, then cut each half into thin strips. Save the leaves in the freezer to use later for broths and stews. Rinse and thoroughly dry the chives; cut the green stalks into 7 cm sections and then slice each section lengthwise into strips.
  3. After the potatoes are cooked, reserve 1 cup of the cooking water. Drain the potatoes thoroughly in a colander. Place the potatoes back into the pot without any water and mash the hot potatoes using a vegetable masher or a potato ricer, if preferred.
  4. Gradually mix in the reserved cooking water, about 1/2 cup (tea), until you achieve a rustic puree—note that the amount of water may vary depending on the moisture content of the potatoes. Taste and season with salt and pepper as needed.
  5. Place an ordinary skillet over medium heat to warm up. Add the olive oil, then the leek, seasoning with a pinch of salt. Sauté for approximately 2 minutes until it becomes very tender. Add the spring and cook, stirring, for 1 minute.
  6. Drizzle hot oil infused with leek and spring over the puree and stir thoroughly (add more water to the puree if needed to achieve the desired consistency). Lastly, incorporate sesame oil. Serve immediately.

Leave a Reply

Your email address will not be published. Required fields are marked *